MTHTrains RealTrax O-3 Betriebsanleitung

MTHELECTRIC TRAINS, INC.7020 Columbia Gateway DriveColumbia, MD 21046-1532O-31SWITCH®MTH RealTrax switches add flexibility and reliability to your O

Aux. ACG (Common)(Black)Aux. AC Power In (Red)Auxiliary power switch operation (to power switch from source other than track power):Figure 9:Multiple

Auxiliary power operation of multiple switches through single Remote Switch (simultaneous identical throws):Figure 11:Auxiliary power operation of mul

Auxiliary power operation of multiple switches through single Remote Switch (simultaneous opposite throws):Figure 12:Aux. ACG (Common)(Black)Aux. AC P

The RealTrax O-31 Switch can be installed into O-Gauge tubular rail layouts with the use of three RealTrax Adapter Track sections. Simply attach one

Main Line“A” Line“B” LineThe following layout wiring diagram illustrates the use of two switches wired for simultaneous operation, identical throw. W

15Wiring Instructions:1) Connect the Powered (Red) transformer output to the Powered (Red, center rail) terminals of the Main Line, “A” Line and “B” L

CAUTION - ELECTRICALLY OPERATED PRODUCT:Not recommended for children under eight years of age without adult supervision. As with all electric product

Table of ContentsIntroduction: 3Switch Operating Instructions: 4®RealTrax O-31 Switch Components: 4Screw Terminal Definition: 6Remote Switch Wiring I

IntroductionThank you for purchasing the MTH Electric Trains RealTrax O-31 Switch. As with all RealTrax products, you will find the O-31 Switch easy

1) Switch:Consists of the roadbed, rails, points, frog, screw terminals, operating circuitry and mechanisms.2) Screw Terminal Cover:Plastic cover that

512345Figure 1a:

Screw Terminal DefinitionThere are five Screw Terminals located under the Screw Terminal Cover on the straight edge of every RealTrax Switch. The pos

Remote Switch Wiring InstructionYou will have to wire the RealTrax O-31 Remote Control Switch to the proper Screw Terminals. To do this, follow Illu

3b3a3cChanging Switch Block Position:Figure 4:To change the position of the Switch Block, follow the steps below:1) Remove the Switch Block by pulling

ACGTrack AC outAccessory Operation from Switch Track AC Out Screw Terminal:Figure 5:Multiple switch operation through one Remote Switch (track power,