MTHTrains 4-6-0 Steam Freight/Passenger Set Betriebsanleitung PDF herunterladen (Seite 45)

DCS Remote Commander

The following Guide will help you trouble shoot your DCS Remote Commander

handheld remote.

Troubleshooting Guide

WARNING – DO NOT CONNECT AC POWER TO THE TRACK

WHEN OPERATING AN HO ENGINE. PERMANENT DAMAGE

WILL OCCUR TO THE ENGINE.

RailKing 4-6-0 Steam Freight/Passenger Set with Proto-Sound® 3.0

Engine address must be set to

factory default. The engine must be

reset to factory defaults using either a

DCS System or a DCS Commander.

Make sure that you have the

DCC/DCS Switch set to ‘DCS’.

Otherwise your engine will not

function properly in DCS Mode.

Replace the batteries in the

handheld remote with two fresh

“AA” batteries. Be sure the remote

is generally pointing toward the

receiver base within 20 feet.

Remove red lens and make sure IR

receiver is centered.

Solution

Symptom

Ensure SU/SD has been pressed.

Press the VOL button then press +

on the throttle control to raise the

volume

1. Ensure the model has coil-

wound proto-couplers.

2. Press the CPLR button then

press + or - on the throttle control

within 2 seconds to fire the front (+)

or rear (-) coupler.

Press the VOL button then press +

or - on the throttle control within 2

seconds to raise or lower engine

volume

Press the DIR button to cycle

through all four PFA sequences

Engine must be standing still to

play the Idle Sounds

Engine does nothing when Start-Up

is pressed

Green light on receiver is not

flashing when a button is pressed

on the handheld remote

Engine has no sound

Engine’s coupler will not fire

Engine only plays first PFA

sequence sounds

Engine Volume is not adjusting

when the throttle control is pressed

Idle sounds are not playing when

the SND button is pressed

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 57 58

Kommentare zu diesen Handbüchern

Keine Kommentare

MTHTrains 4-6-0 Steam Freight/Passenger Set Betriebsanleitung Seite 45

Kommentare zu diesen Handbüchern